Differences

This shows you the differences between two versions of the page.

--- oxides_system [2013/01/04 08:46] – torren
+++ oxides_system [2013/02/27 09:09] (current) – boltje
@@ Line 89: / Line 89: @@
   - You will see that the conditioning of the target takes quite a while, check that while conditioning the voltage goes down to about the previous value in the logbook.
   - Presputter for >1 hour
-  - Program the heater in the meanwhile. There is a recipe for YBCO.
+  - Program the heater in the meanwhile.
 == Sputtering ==
@@ Line 116: / Line 116: @@
 |  Pt      | 20120711  |   Pt-01   |   1 mbar, 35mA, 603V, 19W, 15min        |     X-ray       |  11.5 nm  | 0.766 nm/min   |
 |  LAO     | 20121210  | from Ishrad | DC 0.8 mbar, 30W                      |                 |           | ~0.18 nm/min   |
+====== Tech stuff ======
+  * Targets: 2 inch OD, 0.125 inch thick
+  * Backingcup: 53mm OD, 6.3mm thick