NanoWiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== March 2016 revolution ======

====== High priority issues ======
Issues in this category are such that they affect the essential functionality of the instrument.

  * AFM is not working. RHK staff has maintained there is some issue with the optics, first the laser amplifier was not working and then it was the photodiode. The photodiode was troubleshoot in the end of February 2016 and was indeed disconnected in at least one quadrant. Bert has been notified about this and it should be rectified during the March revolution.
    * Update [20160304]: There has been significant progress on this issue. The photo diode is fixed on both sides. On one side the cable had simply come off and on the other side the soldering from this autumn short-circuited the cable as it connected the shield with the core. The connector was changed to a new one and it was soldered on by ELD with UHV compatible solder (it is supposed to be crimped but the cable was too thin). The laser has also been tested and works fine. An attempt to test this with the system has been made with the laser aligned on the cantilever but the signal remained low. The signal directly from the photo diode however, is still in the range of 200-300 mV when the laser is on. When the preamplifier from RHK is connected it goes down to single millivolt range. RHK has been notified of this on 20160304. One last thing that can be tested is to tune a cantilever with the low signal to indicate if the piezo on the stage works properly. Additionally, the laser spot on the photo diode is very large, almost covering all quadrants. If it is a differential amplifier, this would give a low signal if the signal in all the quadrants are almost the same. Figuring out if this is normal behavior would be good.
  * LEED is not working. The manuals procedure for starting the LEED was followed and the current readout did not show any current. The filament was removed and seems OK, so other troubleshooting ideas have to be explored. VACGEN has been contacted for suggestions. The power supply will be given to the ELD in the first week of March 16.
    * Update [20160304]: The power supply has been handed over to Bert. Joan in Irene Groot's group has offered to lend us a spare power supply to test our optics but this cannot be done until pump down (filament needs 10^-8 mbar).
  * Calibrate and document the load lock pressure gauge pump down time. See below. Can only be done after the instrument is baked and pumped down again.
  * Pressure gauge: Update [20160304] filaments in the main chamber were broken when we opened the system. The filaments themselves where cut in the middle and there was a large mass of some residue on the filament cage. What this white-greenish powder was is unclear. Titanium oxide? Molecules? The filaments have been replaced with new wires from FMD but the new wires are slightly thinner, so perhaps a lower current is needed and a re-calibration is definitely needed. Perhaps mounting a spare pressure gauge for now and having redundancy until next time we open, would be a good idea?


===== Priority issues =====
  * Pressure gauge for load lock is not functioning properly. The symptom is that the gauge cannot show the lowest range of pressures, so when pumping down the pressure goes down but the gauge stops showing the proper value at a much higher pressure than the range of the gauge. The workaround for now, is simply pumping the load-lock for while longer when the gauge stops moving. How long a while is still needs to be calibrated and documented. Bert has been notified and hopefully this will also be addressed.



----

=== Low priority issues ===

The electrodes on some of the parking spots for the evaporation (top parking in the prep chamber) does not work.